Technical Data - Nakayama PRO ES7250 Mode D'emploi

EN
If the lubrication system does not work properly, check if the oil filter and all oil-ways are clean and free from obstructions. If it is still not working, contact an
authorized service center.
Intended use/Not intended use
The chainsaw with telescoping arm is intended for removing branches from trees. It is not suitable for extensive sawing work and felling trees or for the sawing
of materials other than wood. Please observe that our machine was not designed for use in commercial, technical or industrial applications. We assume no
liability if the machine is used in commercial, technical or industrial applications or for equivalent activities.
Symbols
IMPORTANT: Some of the following symbols may be used on your tool. Be sure to study them and learn their meaning. Proper interpretation of these symbols
will allow you to use the machine more effectively and reduce the risk of accident.
Indicates danger, warning or caution.
WARNING – To reduce the risk of injury, user
must read instruction manual.
Wear ear protection, eye protection and
helmet when using the product.
Conforms to relevant safety standards.
This product is double insulated electrically
Guaranteed sound power level (tested according to
Directive 2000/14/EC as amended by 2005/88/EC)
Description of main parts (Picture A)
No. Part
1 Guide bar
2 Saw chain
3 Adjusting knob (grey) for saw chain
tension
4 Adjusting knob (grey) for guide bar
tension
5 Cap of oil tank
6 Cover of guide bar and saw chain
7 Adjusting knob for head angle (30
degrees)
8 Quick clip of telescopic pole
Remark: Above are all assembled in the standard delivery when the packaging is unsealed.
6
Wear gloves and safety boots to protect
against electric shock
Clothing must be sturdy and snug-fitting, but
allow complete freedom of movement.
No.
9
10
11
12
13
14
15
16
WWW.NIKOLAOUTOOLS.GR
Protect the machine from the damp and
never expose it to rain.
SWITCH OFF: Remove plug from mains before
cleaning or maintenance.
SWITCH OFF: Remove plug from the mains
immediately if the cable is damaged or cut.
Maintain a minimum clearance of 10 m from
current-carrying lines. Life-threatening danger
from electric shock
WEEE symbol. Tools that are no longer usable
should not be disposed of with household
waste but in an environmentally friendly way.
Please recycle where facilities exist. Check
with your local council authority for recycling
advice.

Technical Data

Rated Voltage: 230V~50Hz
Rated Power: 750W
Bar Length: 20cm (8"")
Chain Speed: 11m/s
No-Load Speed: 6000/min
Cable Length: 0.25m
SDS Chain Tensioning
Part
Pole (tube)
Sponge sleeve
Seat for shoulder strap
Rear handle
On-off switch
Lock-off button (at the other side of
machine)
Shoulder strap
Guard of guide bar and chain