Assembly Instruction; Final Assembly - Signature Design by Ashley L000718 Instructions De Montage

ASSEMBLY INSTRUCTION:

READ AND SAVE THE INSTRUCTIONS.
THIS PRODUCT IS FOR INDOOR USE ONLY! OUTDOOR USE COULD RESULT IN SHOCK, FIRE OR SERIOUS BODILY INJURY
OR DEATH. ALL WIRING MUST BE DONE IN ACCORDANCE WITH NATIONAL AND LOCAL ELECTRIC CODES. IT IS STRONGLY
RECOMMENDED THAT YOU USE A QUALIFIED ELECTRICIAN.
WARNING
THIS FIXTURE MUST BE MOUNTED TO A UL LISTED OUTLET BOX CAPABLE OF SUPPORTING THE FIXTURE.
FAILURE TO FOLLOW THIS REQUIREMENT COULD RESULT IN THE FIXTURE FALLING CAUSING SERIOUS BODILY INJURY OR
DEATH.
WARNING
To avoid shock, fire or serious bodily injury or death it is very important that the electricity servicing
the fixture is turned off before and during installa on.
1. A ach the cross bar to the ceiling outlet box using the two screw provided with the outlet box. (Note: If the screws with the
outlet box are too short, use the (2) 1-4 x 1-1/4" screws provided in the moun ng hardware package). Next, screw the screw
collar loop onto the nipple and then screw the nipple into the cross bar.
2.Slide the screw collar nut and then the canopy onto the end of the chain. Then fasten the end link of chain to the screw collar
loop.
3. Insert the fixture wire and the ground wire up through the nipple. Connect the white or ribbed fixture wire to the white
supply wire in the outlet box using the TWIST-ON wire connectors provided. Connect the black or smooth fixture wire to the
black supply wire in the same manner. Install the fixture ground wire under the green group screw on the crossbar then connect
the fixture ground wire to the supply ground wire in the outlet box using the TWIST-ON sire connector provided.
4. Tuck the wires carefully inside the outlet box. Spread the electrical splices so that the black wires are on one side of the outlet
box and the white wires are on the other side. Next raise the canopy to the ceiling and secure in place by screwing the screw
collar nut onto the screw collar loop.

FINAL ASSEMBLY

1. Install a 60 wa max. Medium base type "A" bulb (not included) into each socket.
Installa on of a bulb exceeding 60 wa s maximum could result in fire, serious bodily injury or death.
WARNING
2. Slide small metal washer, diffuser, large metal washer over the nipple of stem and secure with the finial.
3. Restore power a er installa on is fully complete. Your fixture is ready for use.
SIGNATURE DESIGN BY ASHLEY
L000718
Crossbar
Ground Screw
Green Ground Wire
8-32 Screw
Supplied with
Mounting Hardware pack
TM All Rights Reserved.
Outlet Box
Black or Smooth
Fixture Wire
White or Bibbed
Fixture Wire
Canopy
September 2022 Page 2 Of 6