Publicité
PARK TOOL CO.
5115 Hadley Ave. N., St. Paul, MN 55128 (USA) www.parktool.com
PCS-9.2 Home Mechanic Repair Stand
Assembly and Set Up
1. Line the Hard Stop (#27) up with the two holes in the Large Vertical Upright
(#7) such that the arrow on the Hard Stop (#27) is pointing upward. Using a
3mm hex wrench, insert the M5 x 12mm Screws (#17) into the holes in the
Hard Stop (#27) and screw them into the Large Vertical Upright (#7). Tighten
to 3.5Nm max (Do Not Overtighten)
2. Slide the Yoke (#3) down the Large Vertical Upright (#7) until it bottoms out
on the Hard Stop (#27). Insert the M6 Flange Nut (#19) into the hex pocket in
the Yoke (#3). From the other side of the Yoke (#3) insert the Knob (#18) into
the hole in the Yoke (#3). Screw in the Knob (#18) until it is fully tightened.
Fully tightened is when both flanges on the Yoke (#3) come into contact with
each other.
3. Slide (#33) collar down the tube (#7) so it comes into contact with the
(#3) yoke. Tighten the knob on the (#33) collar until tight. Any time the
stand is set up and in use, make sure the (#33) collar is tightened down to
the (#3) yoke.
4. Assemble and install the hardware and mating pieces in the order shown
through each Leg (#2) and Leg Strap (#10). Using a 5mm hex wrench and a
13mm box end wrench, tighten the M8 x 60mm Screw (#14) to 5 Nm.
2
3
19
4
10
14
6
8
19
4
7
PCS-9.2
7
18
27
2
11
13
1
1
13
18
16
Instructions / Instructions / Anleitung / Instrucciones
1
3
5
7
7
27
17
17
7
33
3
20
23
21
24
22
Publicité
