Hart HHMLE104 Guide Rapide

HHMLE104
Laser Level
SAFETY RULES
WARNING:
To reduce the risk of injury, the user
must read and understand the operator's
manual before using this product.
WARNING:
Use of controls or adjustments or
performance of procedures other than
those specified herein may result in
hazardous radiation exposure.
WARNING:
The use of an optical instrument with this
product will increase eye hazard.
NOTICE:
Ensure that AAA batteries are installed in
the correct polarity. Improperly installed
batteries can cause damage to the laser
level.
The laser guide radiation used in this laser
level is Class IIIa with < 5mW and 640-660 nm
wavelengths. These lasers do not normally
present an optical hazard although staring at
the beam may cause flash blindness.
 Avoid direct eye exposure when using the
laser and do not project the laser beam
directly into the eyes of others. Serious
eye injury could result.
 Do not remove or deface any product
labels. Removing product labels increases
the risk of exposure to laser radiation.
 Do not place the laser level in a position
t h a t m a y c a u s e a n y o n e t o s t a r e
into the laser beam intentionally or
unintentionally. Serious eye injury could
result.
 Do not operate the laser level around
children or allow children to operate the
tool. Serious eye injury could result.
 Always turn the laser level off when not
in use. Leaving the tool on increases the
risk of someone inadvertently staring into
the laser beam.
 Do not operate the laser level in
combustible areas such as in the
presence of flammable liquids, gasses
or dust.
The following signal words and meanings are intended to explain the levels of risk associated with this product.
SYMBOL NAME
Safety Alert
Indicates a potential personal injury hazard.
Read Operator's
To reduce the risk of injury, user must read and understand operator's manual before using this product.
Manual
Laser Exposure
Laser radiation - avoid direct eye exposure.
1. INSTALLING BATTERIES 2. MOUNTING THE LASER LEVEL TO WALL
Remove bat-
tery cover and
install AAA
batteries (not
included).
Replace cover.
2. MOUNTING (CONTINUED)
Press to stick to surface.
Hart Consumer Products, Inc.
P.O. Box 1348, Anderson, SC 29622
1.800.776.5191 / www.HARTtools.com
 Always ensure the laser beam is aimed
at a surface without reflective properties.
Shiny reflective materials are not suitable for
laser use.
 Do not disassemble the laser level. There
are no user serviceable parts inside.
 Handle the laser level with care. Treat it
as you would any other optical device such
as a camera or binoculars.
 Avoid exposing the laser level to shock,
continuous vibration or extreme hot or
EXPLANATION
Use push pin
to mount to
wall.
OR 
3. USING THE LASER LEVEL
Turn level on.
Adjust position
as needed to
center bubble(s)
in appropriate
vial(s).
Warranty details available at www.HARTtools.com
Proof of purchase is required to validate the 3-year limited Warranty.
HART, the HART logo and H logo are trademarks of Techtronic
Cordless GP.
cold temperatures. Damage to the tool
and/or serious injury to the user could result.
 Do not mix old and new batteries.
 Do not mix alkaline, standard, or
rechargeable batteries.
 Save these instructions. Refer to them
frequently and use them to instruct others
who may use this laser level. If you loan
someone this laser level, loan them these
instructions also.
Apply
Remove backing
removable from removable
adhesive
adhesive strip
strip (not
and prepare to
provided) on stick laser level
to wall. on to the wall.
4. REMOVING THE LASER LEVEL
Remove laser
level from
surface.
995000994
8-15-19 (REV:04)