Cleaning And Maintenance - Bestron AAC5000 Mode D'emploi

OPERATION - Timer function
The appliance is equipped with a timer with allows you to shut off the appliance at the end of a predetermed
time. Press the "timer" button repeatedly to set the shut-off time to 1, 2, 4, 6 or 8 hours. Press the "timer"
button again to deactivate the timer function.
OPERATION - Breeze mode
The appliance is equipped with a Natural Breeze and a Sleep Breeze function. Use the "mode" button
combined with the "speed" button to activate a range of functionalities:
Natural Breeze
In Natural Breeze mode, the appliance will mimics natural wind, using alternating wind speeds. Press the
"mode" button to activate Natural Breeze mode. The indicator light next to "natural" lights up. Press the
"speed" button to choose between:
• Speed "high":
• Speed "medium":
• Speed "low":
Sleep Breeze
In Sleep Breeze mode, Natural Breeze mode will change from higher to lower over time. Press the "mode"
button again to activate Sleep Breeze mode. The indicator light next to "sleep" lights up. Press the "speed"
button to choose between:
• Speed "high":
• Speed "medium":
• Speed "low":
Press the "mode" button again to deactivate the Breeze mode.
OPERATION - Remote control
The appliance can also be controlled using the included remote control. The remote control operates on two
AAA batteries (not included). Open the battery compartment on the bottom of the remote, insert the batteries
and close the lid. The buttons on the remote control work the same as the buttons on the control panel, apart
from the "humidifying" function which can not be switched on or off via the remote control.
For optimal use:
• The distance between the appliance and the remote control should,nt be more than 6 meters.
• Point the remote control at the appliance and be sure that the angle is smaller than 30 degrees.

CLEANING AND MAINTENANCE

Over the course of time dust can accumulate between the spokes in the fan housing, and on the fan blades.
Romove any dust with a brush and/or vacuum cleaner.
Replacing the water
The water should be changed every 3 - 4 days even when the appliance is not being used.
1. Remove the plug from the wall socket.
2. Remove the intake filter from the back of the device (see figure 6).
3. Unscrew the screw at the top of the cooling/humidification system (see figure 7).
4. Remove the cooling/humidifying system from the device.
5. Remove the water tank from the device.
6. Empty the water tank, rinse it under the tap and dry it thoroughly.
7. Insert the water tank, the cooling/humidification system and the intake filter back into the appliance.
8. Fill the water tank as described under 'OPERATION - Cooling / Humidifying the air'.
high alternating wind speed.
medium alternating wind speed.
low alternating wind speed.
the appliance operates in Natural Breeze mode "high" for 30 minutes (see
above), then in Natural Breeze mode "medium" for 30 minutes and then
switches to Natural Breeze mode "low" until you switch off the appliance.
the appliance operates in Natural Breeze mode "medium" for 30
minutes and then switches to Natural Breeze mode "low" until you
switch off the appliance.
the appliance operates in Natural Breeze mode "low" until you switch off the
appliance (Sleep Breeze mode not active).
32
EN