Safety Instructions; Maintenance And Cleaning - AL-KO Sawiko UA-750-II Instructions De Montage Et D'utilisation

Installation and operating instructions
Please read this document before use. This is essential for safe working and trouble-free handling. Comply with the safety and warning
instructions in this documentation and on the product. This document is a permanent component of the described product, and should
remain with the machine if it is sold to someone else.

Safety instructions

All screws must be re-tightened with the prescribed torques after approx. 50 to 100 km of travel.
When installing or loading the load carrier, always engage the handbrake and secure the vehicle against rolling
No luggage or cargo may protrude beyond the side of the carrier or the vehicle.
Endangerment of other road users must be excluded.
Observe the national and statutory national regulations regarding load.
The lighting and the registration number on the carrier must not be obscured by the
Luggage or bicycles must be securely fixed in place. The centre of gravity of the load should be in the centre of the
This is the responsibility of the driver. Lashing straps can lose their tension due to the effects of travel and weather.
Check that your cargo is firmly seated at regular intervals.
Attaching and loading the load carrier can change the driving behaviour of your vehicle, especially when cornering and on uneven road
surfaces (e.g. when driving over potholes, uneven ground or railway tracks).
Therefore, drive at a speed adapted to the vehicle and load.
Installation – Instructions for the specialist workshop
Carry out the installation with at least one other person.
Screw size
M6
M8
M10
M12
Recommended tightening torques for dry, non-greased fastening screws (µ=0.14)
Values that deviate from these are given in special notes.
Repair
Important
For the installation of spare parts in our products, we recommend the use of original parts only.
Repairs to electrical cables and safety-relevant components may only be carried out by specialist workshops and specialist personnel.

Maintenance and cleaning

When driving in winter, wash off the residual road salt.
Repair stone chip damage to steel parts with paint.
Check the load carrier for damage before each loading or at least once a year.
Bent or damaged parts must be replaced.
Spare parts can be ordered using the spare parts card.
Self-locking nuts may only be used once.
Disposal
The packaging, machine and accessories are made from recyclable materials, and must be disposed of accordingly.
Torque strength class 8.8
10 Nm
25 Nm
49 Nm
86 Nm
load.
3 / 16
EN
away.
platform.