Assembly - HAMPTON BAY 18824-000 Guide D'utilisation Et D'entretien

ASSEMBLY

1
Preparing the unit for assembly
Carefully unpack all the parts. Protect the assembly surface
to avoid scratching the lamp or the assembly surface.
Pull out any excess power cord through floor lamp base (A)
during all assembly steps to prevent the cord from becoming
twisted.
Thread the bottom tube (B) into the floor lamp base (A).
Thread the middle tube 1 (C) into the bottom tube (B).
Thread the middle tube 2 (D) into the middle tube 1 (C).
Thread the top tube (E) into the middle tube 2 (D).
E
D
C
B
A
3
Installing the light bulb and harp
Install one 3-WAY 100 Watt type A bulb into the socket
assembly (F). (Light bulb not included).
Pinch and insert harp (G) into the saddle on the socket
assembly (F).
Slide the caps on harp (G) over
assembly (F) to secure.
G
F
NOTE:
NOTE: Do not exceed the maximum wattage.
the saddle on the socket
2
Inserting the body
Thread the socket assembly (F) into the top tube (E).
F
E
4
Installing the lamp shade
Remove the nial (I) from the harp (G).
Place the shade (H) on harp (G) and secure with nial (I).
I
H
G
4