Télécharger Imprimer la page

Napier PROZ 51100 Guide Rapide page 2

Publicité

Les langues disponibles

Les langues disponibles

CAUTION
• Do not use candles, matches or open flames of any kind in or
near the tent
• Do not cook inside the tent
• Build campfires downwind and several meters away from the
tent. Be sure to fully extinguish fires before leaving a campsite
or before retiring for the night
• Exercise extreme caution when using fuel-powered lanterns or
heaters inside or around the tent. Use battery-operated
lanterns whenever possible
• Do not refuel lamps, heaters or stoves inside the tent
• Extinguish or turn off all lanterns before going to sleep
• Do not smoke inside the tent
• Do not store flammable liquids inside a tent
• NEVER run the vehicle engine when the tent is attached
• Do not install the tent when the temperature is below
0ºC/32ºF or when your vehicle is wet, it may cause damage
• Allow adequate ventilation inside the tent at all times
• Do not attempt to drive the vehicle with the tent attached
CAMPSITE SELECTION
• Select a smooth level campsite clear of rocks, branches and
other hard or sharp objects
• Park the vehicle in the chosen campsite. Turn off the engine
and apply the parking brake
TRUCK TENT SETUP
1. Set up your PROZ Truck Tent as indicated in the instructions
provided with your Truck Tent.
SPORTZ LINK TENT SETUP
2. Remove the tent from the tent bag and lay it flat on the ground
with the vehicle sleeve facing the cargo area of the vehicle.
At this point, do not stake the tent to the ground.
3. Assemble all poles by unfolding each section. You will have
two (2) long tent poles (tent structure) and one (1) short pole
(rainfly).
4. A. Insert one of the long poles diagonally, corner to corner
through the pole sleeve in the roof of the tent. Repeat with
the other pole
B. Place one pole end into the grommet hole located at the
corner of the tent. Repeat on the other end of the pole,
creating an arch. Repeat with the other pole
NOTE: The poles may get stuck in the pole sleeve. Do not force
the pole - gently lead it through the fabric sleeve.
5. Once the tent is standing, attach the plastic clips to the tent
poles.
2 of 7

Publicité

loading