Publicité
ASSEMBLY
(Figures 1 through 6)
Tools Required: #2 Phillips Head Screwdriver (not included)
Carefully remove the Heater from the bag and the carton. For ease of
assembly, lay the Heater down so that the front grill and control
panel are facing up.
(8) - M5 X 13mm
Screws Shown Actual Size
1. Locate the Power Supply Cord at the bottom of the Heater.
Thread the Power Supply Cord through the center of the Col-
umn Support Assembly.
2. Attach the Column Support Assembly to the Motor Base with
(4) M5 X 13mm Screws. Make certain to align the Key on the
Motor Base with the Locating Notch on the Column Support
Assembly. (Figure 2)
Power
Supply
Cord
3. Assemble the Base by interlocking the Bosses into the Boss
Holes. (Figure 3)
Bosses
Key
Rev. D 5/09
MODEL 1DKX5/8365
(2) - M4 X 13mm
Figure 1
Motor
Base
Key
Column Support
Assembly
Figure 2
Boss
Holes
Figure 3
4. Secure the Base halves with (2) M4 X 13mm Screws.Thread the
Power Supply Cord through the large hole in the Base Assembly.
NOTE: The Cord Channel on the bottom of the Base should
be towards the back of the Heater. (Figure 4)
Cord
Channel
Base
Assembly
5. Align the Base Assembly with the Column Support Assembly.
Make certain to align the Locating Notch on the Column Sup-
port Assembly with the Key on the Base Assembly (Figure 5).
Attach the Base Assembly to the Column Support Assembly
with (4) M5 X 13mm Screws. Gently pull any excess slack of
the Power Supply Cord and place it in the Cord Channel of the
Base Assembly. (Figure 6)
Key
Base
Assembly
Cord
Channel
3
Power Supply
Cord
Figure 4
Locating
Notch
Figure 5
Column
Support
Assembly
Power Supply
Cord
Figure 6
8365ESF
Publicité
