VONN Lighting VAW1261 Guide D'installation

VONN Lighting
VAW1261
Model:
Parts List
A B
Installation Guide
LED INFO & WARNINGS
• Please read and comprehend the entire manual before attempting to
assemble, operate, or install the product.
• Make sure that you have all necessary parts by checking the parts list. If
any part is missing or damaged, please contact VONN Lighting
Customer Service at 888-604-8666 for a replacement.
•
All parts must be used as indicated in these instructions. Do not substitute
any parts, leave parts out, or use any parts that are worn or broken.
• Inspect the LED fixture prior to installation to make sure that it has not
been damaged during shipping.
•
Please handle the LED light with care when unpacking. Do not apply
pressure to the LEDʼs, do not open any factory sealed compartments, and
do not touch the LEDs with your hands.
VONN highly recommends to use a qualified, licensed electrician to install
the fixture.
•
VONN recommends to install the fixture on its own independent circuit.
Do not install the fixture on the same circuit with other appliances, or
HVAC systems.
• Do not remove or replace VONN manufactured driver that is provided
with the fixture.
•
VONN recommends ELV (Electric Low Voltage) type dimmers for this
fixture.
•
Shut "OFF" the electricity at main fuse box.
•
Place the wall switch in the "OFF" position of the room you are installing
the fixture.
A.
B.
D E
C.
D.
E.
Tools You May Need
GOGGLES
TAPE MEASURE
Mounting Bracket x 1
Outlet Screws x 3
Wire Connectors x 3
Ground Screw x 1
Canopy Screws x 2
PHILLIPS
RUBBER
SCREW DRIVER
GLOVES
Circuit Box
ON
DRILL
LADDER
©VONN Lighting,2019