Table des Matières
Publicité
HPW 151i PRO
Discharge residual pressure before disconnecting
the hose from the product.
Check before each use, and at regular intervals,
that all metal fasteners are tight and the prod-
uct's components are in good condition; inspect
for broken or worn parts.
PRODUCT SPECIFICATIONS
INTENDED USE
If connection is made to a potable water system, the
system shall be protected against backflow.
This high pressure cleaner is designed with a rated in-
put current. The intended use of this product covers
the cleaning of vehicles, buildings, terraces, facades
and garden equipment using clean water and biode-
gradable chemical detergents. Likewise the product
can be used to clean paving slabs or rain gutters.
This product may not be used to clean clothing, shoes
and other textiles. The water jet should not be directed
against persons, animals, any electrical equipment or on
the product itself. Do not flush any objects which con-
tain health hazardous materials. The product must not
be run with inflammable, explosive and toxic liquids.
For safety reasons it is essential to read the entire
instruction manual before first operation and to ob-
serve all the instructions there in.
TECHNICAL DATA
Article Number
Model
Max. Pressure
Working Pressure
Working Water Flow
Rated Water Flow
Auto Stop System
Motor Specification
Motor Type
Voltage
Frequency
Rated inlet
Max. water inlet tem-
perature
Protection Class
Weight
45 975
HPW 151i PRO
151
bar
bar
120-130
l/h
384
l/h
444
√
INDUCTION
V
220-230
Hz
50
W
2.400
°C
40
IPX5
kg
32
Sound emission values determined according to
EN 60335-1, EN 60335-2, EN 62233
Typically the A-weighted noise levels of the prod-
uct are:
Sound pressure level
Guaranteed sound
power level
Uncertainty Κ
Vibration total values a
and uncertainty K determined according to EN
60335-1, EN 60335-2, EN 62233
Vibration level max:
a
h
Κ
IDENTIFICATION (Fig.1)
1. Handle
2. High-pressure hose
3. Power cord holder
4. High-pressure hose hook
5. OFF/ON Power cord
6. Adjusts witch
7. Handle
8. Wheel
9. Adjustable Pressure valve
10. Water in let
11. Water outlet
12. Nozzles
13. Trigger gun
14. Trigger gun hook
15. Spray wand
16. Nozzles protector
17. Detergent bottle
INSTALLATION
WARNING: Make sure that you replace the black
plastic oil cap on the top of the pump with the yel-
low dipstick cap (if not already in position), before
operating the pressure washer.
1. HANDLE INSTALLATION
Fit the handle bar on the base of the high pressure
washer pump, as shown in (Fig. 2).
2. SPRAY WAND INSTALLATION
Fit the spray wand into the gun and rotate it until
the two parts arecompletely locked (Fig. 3).
3. CONNECTION OF THE HIGH PRESSURE HOSE
TO THE TRIGGER GUN
Connect the adaptor of the high-pressure hose to
the trigger gun and twist the nut as indicated to
secure the connection (Fig. 4).
English |
db(A)
74
db(A)
90
dB
3
(triax vector sum)
h
m/s²
2,2
m/s²
0,7
www.ffgroup-tools.com
9
Publicité
Table des Matières
