Technaxx TX-100 Manuel D'utilisation page 5

Remote Control & Functions
Activate (Arm)
The PIR sensor can be activated by pressing the remote control
button shortly.
Once the PIR sensor is activated, it takes about 5 seconds until the
device is armed. When armed the blue light flashes every 5 seconds.
After human action is detected, blue light flashes quickly each
second and the siren is noising loudly. When the alarm will work
continuous for two minutes (working current under alarm status is
26mA)
Deactivate (Disarm)
To deactivate the PIR sensor and turn off the alarm sound, press the
button on the remote control shortly.
You will hear 2x short "beep" and the blue light stops flashing.
The max. distance to disarm the device before getting back into the
car is ~8m on open field.
Shut OFF device
If you press the remote control button long (3-4 seconds) you will
hear one short "beep", and one long "beep" sound.
After that the device's battery is turned off. Not just the PIR sensor is
shut off, the whole device is shut off for long time no use or for
transportation.
All indicator turn off, except the charging indicator (red) when the
device is still plugged into an active cigarette lighter socket.
The device can only be activated/armed when you plug it into the
cigarette lighter socket again, or as soon as the cigarette lighter
socket gives a new charge impuls to the device. The remote control
is not working when device is shut off.