Installation Instructions; Cleaning And Maintenance - Oceanic OCEACWC12LCD Guide D'utilisation

INSTALLATION INSTRUCTIONS

Before putting your wine cellar into service
 Remove all inner and outer packaging components.
 Check that none of the following parts are missing:
■ 1 operating manual
 Before connecting your device to a power supply, allow it to stand
upright for about 2 hours. This reduces the risk of malfunction of the
refrigeration system due to handling during transport.
 Clean the inner surfaces of the unit with a soft cloth and warm water.
 Place your unit on a floor strong enough to support the weight of the
fully filled unit.
 Make sure the unit is level by adjusting the front feet underneath the
unit. Make sure that the cellar rests on its feet in a stable manner.
 Install the appliance away from direct sunlight and heat sources
(radiator, hot plate, etc.). Direct sunlight can damage the unit's coating
and heat can increase its power consumption. If the ambient
temperature is extremely cold or hot, this may prevent the unit from
operating properly.
 The unit is not designed to be installed in a basement or cellar.
 This unit is designed exclusively for indoor use.
Caution: Make sure that the unit is kept away from any substance that
may cause combustion.
 Check that the water tank is in place before connecting the unit.

CLEANING AND MAINTENANCE

Cleaning your wine cellar
 Unplug your wine cellar and take out all the bottles.
 Clean the outside of the unit with hot water and a mild detergent.
 Remove the water tank at the bottom of the unit, then wash it.
Moving your wine cellar
 Remove all bottles and disconnect the wine cellar.
 Tape all loose parts inside your wine cellar.
 Turn the feet to adjust their height to the minimum to avoid damage.
 Tighten the door to keep it closed.

Be sure to keep the wine cellar upright during transport.
14