Technical Characteristics - Jeulin VTT method Mode D'emploi

®
VTT method
®
VTT Ergolab Burette sensor
Ref :
472 043
ENGLISH
2.3 Commissioning with the VTT console
•
Connect the sensor.
•
Switch on the VTT
If the sensor is not detected, update your VTT console connected to the PC
using the floppy disc via the Espace VTT software.
•
Connect the console to the PC,
•
Open the Espace VTT by clicking on the icon
computer",
•
Click on Install
•
Install the Biosflash software.
2.4 Commissioning with the ESAO Primo
The sensor is automatically detected by the sensor.
•
Connect the console to your PC,
•
Connect the sensor to the console,
•
Start your acquisition software.

3 Technical characteristics

Measuring range 0 / 50 ml
Resolution 50µl resolution
Accuracy +/- (1% of the measurement + 150µl) after calibration
Calibration With 2 potentiometers: for zero (2) and for the gradient (3)
®
The VTT Ergolab burette sensor uses signals from the SA electronic burette
(Part no.: 701 338, not supplied). The connection is made by 2 banana-
banana safety cords of Ø 4 mm.
4 Calibration
4.1 Calibration of the Ergolab SA electronic
burette
For better accuracy, it is recommended that the burette be calibrated
beforehand: refer to the product instructions.
®
console.
,
6
present in "My