Connection Example - Kathrein EAX 2512 Mode D'emploi

Connection example

/584
Basic installation and safety instructions
Q
The equipment described is designed solely for the installation of satellite receiver systems
Q
Any other use, or failure to comply with these instructions, will result in voiding of warranty cover
Q
The equipment may only be installed in dry indoor areas.
Do not mount on or against highly combustible materials.
Q
The equipment must be provided with an earthing wire (Cu, at least 4 mm
Q
The safety regulations set out in the current EN 60728-11 and EN 60065 standards must be complied with
Q
Fixings: Wood screws, max Ø: 4 mm
Q
Connector: HF plug 75 Ÿ (series F) to EN 60169
Q
Unused subscriber ports should be closed off by 75-Ÿ resistors (e.g. EMK 03)
• If the inner cable con-
ductor diameter is
greater than 1.2 mm
or in case of burr, the
device sockets may be
destroyed.
Electronic equipment is not household waste - in accordance with directive 2002/96/EG OF THE EUROPEAN PARLIAMENT AND THE COUNCIL dated
27th January 2003 on used electrical and electronic equipment, it must be disposed of properly. At the end of its service life, take this unit for disposal to
an appropriate of¿ cial collection point.
Internet: www.kathrein.de
KATHREIN-Werke KG • phone +49 8031 184-0 • Fax +49 8031 184-306 • Anton-Kathrein-Straße 1 - 3 • P.O. Box 100 444 • 83004 Rosenheim • GERMANY
Max. 2 mm excess
length
Clamping torque
max. 3 Nm
(danger of overwin-
ding)
2 )
Diameter
0.6-1.2 mm
free of burrs