TPI TASKMASTER 5100 Serie Instructions D'installation

TASKMASTER
5100 SERIES
PRODUCT FEATURES
• Forced air electric unit heater available in 208,
240/208, 227, 480, 550 or 600 volt as standard.
• Ten standard heating capacities of 3.3 KW/11,260
BTUH thru 50.0 KW/170, 600 BTUH.
• 208 and 240/208 volt models are single phase field
convertible to three phase on 3.3 thru 10.0 KW
Models. (Single phase only available on 3.3, 5.0, 7.5
and 10 KW 277 volt models.
• Specially designed inlet louver allows the fan to pull
cool air evenly across the high mass all-steel element.
• Outward drawn venturi and adjustable louver
assembly further directs the outlet air in a uniform
pattern to meet specific air pattern requirements in
either the horizontal or vertical mounting position.
• Optional wall/ceiling or vertical mounting brackets (as
required).
IMPORTANT: OWNER SHOULD RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
Horizontal or Vertical Mounting
Industrial / Commercial
NOT FOR RESIDENTIAL USE
ATTENTION: Read carefully
attempting to install, operate or service
the TaskMaster Unit Heater. Retain these
installation instructions for future use.
Unit Heater
before
• Four position weld nuts supplied in case top and back
for field mounting by threaded rods or eye bolt with
chain. (Hardware supplied by others).
• Optional radial or anemostat diffusers lending air
pattern versatility when mounted vertically.
• Modular control kits for field installation. Disconnect
switch, thermostat, summer fan switch, heat recovery
thermostat. All kits with spade terminals (Except
• disconnect switch).
• Single point terminal board wiring of integral control
kits.
• 24 volt low voltage control circuit standard on all
contactor and transformer models.
• Roomy control box with access door locked into
position by two (2) 1/4 turn fasteners for ease of
installation.
1 of 20
INSTALLATION
INSTRUCTIONS
& PARTS LIST
ECO 1-7874
REV. 10/22
FORM: 9632