Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SurfBeam
2 Satellite Modem User's Guide
®
STEP 3
1.
Plug the in-line power supply into the SurfBeam 2 SM, and then into the
AC power source.
2.
AC requirements are: 115 or 220 VAC, 50-60 Hz.
STEP 4
Watch the SurfBeam 2 SM front panel indicators. The RX indicator should flash
while acquiring the satellite signal. When the RX indicator goes on steady, the SM is
registered.
Note: You must configure your computer to obtain an IP address from the
DHCP server. Refer to your computer's operating system (O/S) documentation
for instructions.
Status Rx
Tx LAN
Key
Off:
On:
1108591 Rev. 005
Power is off
BIST of LEDs - all LEDs on for 2 seconds after power up
FL Scanning in process
Network Entry in progress
DHCP/Config TFTP in progress
Online
Software Download in progress
Fault detected
Installation mode in progress
Terminal is transmitting during normal operation
Terminal is receiving during normal operation
Blink:
Flicker:
SurfBeam
SM
In-Line Power Supply
LAN:
3
Publicité
Table des Matières
