OHAUS RANGER 3000 Manuel D'instructions page 3

Ethernet Interface
INTRODUCTION
This Ethernet interface kit is for use with the Ranger 3000, Ranger Count 3000 and Valor 7000
scales.
KIT CONTENTS
 Ethernet PC Board
 Screws (4)
 Instruction Manual
 Cable
INTERFACE INSTALLATION
Install the Ethernet Interface on the underside of the balance as shown.
1. Remove the red interface options cover.
2. Install the Interface PCB. Push it through the pins and secure it with the 4 screws.
Pins
Groove
for cable
3. Connect an Ethernet Cable.
4. Place the cord in the groove (see step 2) and put the red interface option cover back on.
Screws
EN-1