Triangle S02 Notice De Montage page 3

ASSEMBLY OF S02 STAND
EN
1-
Route the speaker cables through the
dedicated holes.
x4
2-
Attach the spikes on the bottom plate. The
provided nuts enable you to adjust the spikes
to assure alignment with your floor. Use the
dedicated floor protectors if necessary.
Holes for cable management
x4
3-
Fasten the bottom plate to the tubes.
Caution : the two tubes are not identical, take
notion and assemble it exactly as per the schema.
x4
4-
Secure the top plate to the tubes.
In order to assur a perfect alignment of the
different parts, it is advised to engage the 8
screws without screwing them all the way.
Once this step done, check if the different parts
are well aligned before final screwing.
x1
x1
x4