sensory or mental
capabilities or with a lack
of experience and
knowledge; provided
that they have been
given adequate
supervision or
instruction concerning
how to use the appliance
in a safe way and
understand the hazards
involved.
• Children should not play
with the appliance.
Cleaning and user
maintenance should not
be made by children
without supervision.
• Locks :If your
Fridge/Freezer is fitted
with a lock, to prevent
children being entrapped
keep the key out of
reach and not in the
vicinity of the appliance.
If disposing of an old
Fridge/Freezer break off
any old locks or latches
as a safeguard.
LEVELLING
If the refrigerator is not leveled during installation.
The doors may not close or seal properly,
whichcausing cooling, frost or moisture problems.
It is very important for the refrigerator to be leveled
in order to function properly.
To level your refrigerator you may either turn the
level leg clockwise to raise that side of the
refrigerator or turn counter-clockwise to lower that
side. To ensure proper ventilation for your
refrigerator, allow for 200mm space on each side
between walls 200mm space between back of your
refrigerator and the wall, and 300mm space between
counter top and the top of the appliance.
If you are installing your refrigerator next to a fixed
wall, leave sufficient space on the hinge side to allow
for the door to swing open
Never install your refrigerator near a heat source or
in direct sunlight.
STARTING TO USE
Before you starting to use the freezer, please check
that:
1.
The interior is dry and air can circulate freely
at the rear.
2.
Clean the interior as recommended under
"TAKE CARE" section (electric parts of the
refrigerator can only be wiped by dry cloth).
3.
Do not switch on until 2 hours after moving
the fridge/freezer. This will reduce the
possibility of a malfunction in the cooling
system from handling during transportation.
4.
Before connecting the Refrigerator to the
mains supply position. The thermostat control
dias is located inside the Fridge compartment.
ELECTRICAL REQUIREMENT
WARNING!
DO NOT REMOVE EARTH CABLE
DO NOT USE AN ADAPTOR
DO NOT USE EXTENSION CORD
Failure to follow these instructions can result in
death, fire or electrical shock.
Before you move your refrigerator into its final
location, it is important to make sure you have the
proper electrical connection. Recommended Earthing
Method
A 220~240 Volt/50 Hz AC only 10 ampere fused and
properly earthed electrical supply is required. it is
recommended that a separate circuit serving only
this appliance be provided. Use a socket which
ideally cannot be turned off with a switch or pull
chain ,Do not use an extension cord.
NOTE: Before performing any type of installation,
disconnect the refrigerator from the electrical
source. When you are finished, connect the
refrigerator to the electrical source and reset the
control to the desired setting.
APPLIANCE OPERATION
To obtain the best possible results from your freezer,
it is important that you operate it properly.
Temperature Control
Controls for the freezer are located at the top of the
outside cabinet. When you first install your freezer,
set the Thermostat dial at 7. Give your freezer time
to cool down completely before adding food. It is
best to wait 24 hours before adding food
The thermostat dial controls the temperature. The
higher number setting, the longer the compressor
will run to keep the temperature colder.
The setting of "3" should be appropriate for home or
office use.
19