Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

H-2813
ICE MELT SPREADER
TOOL NEEDED
Pliers
NOTE: Read all directions prior to assembly. This
spreader comes partially assembled. Control
rod installation will require pliers.
• Spreader is designed to be pushed at three miles
per hour, which is a brisk walking speed. Slower or
faster speeds will change the spread patterns.
• Prior to first use, coat all metal parts (inside and
outside) with a spray lubricant to help prevent
corrosion.
• Clean spreader thoroughly after each use. Wash
with clean water and dry thoroughly. Spray a light
coating of oil on all metal parts (and inside all of the
tubing) to help prevent corrosion.
• Gears are permanently lubricated at the factory.
Do not open the gearbox or dirt may enter.
PAGE 1 OF 3
1-800-295-5510
uline.com
INSTRUCTIONS
1.
2. Install control rod into handle as shown above.
3. Rotate forward.
4. Insert control rod into pivot and secure with hair pin
5. Assembly is complete. Set the stop on the control
Pour le français, consulter la page 3.
Remove spreader from carton and swing handle
into upright position. Tighten wing nuts to secure.
(See Figure 1)
Figure 1
Handle
Control Rod
clip.
assembly for the desired setting and your spreader
is ready to operate.
Para Español, vea página 2.
Hair Pin
Clip
0422 IH-2813

Publicité

loading

Sommaire des Matières pour Uline H-2813

  • Page 1 Para Español, vea página 2. Pour le français, consulter la page 3. H-2813 1-800-295-5510 uline.com ICE MELT SPREADER TOOL NEEDED Pliers INSTRUCTIONS NOTE: Read all directions prior to assembly. This Remove spreader from carton and swing handle spreader comes partially assembled. Control into upright position.
  • Page 2 H-2813 800-295-5510 uline.mx ESPARCIDOR DE DERRETIDOR DE HIELO HERRAMIENTA NECESARIA Pinzas INSTRUCCIONES NOTA: Lea todas las instrucciones antes del Retire el esparcidor de la caja y gire el asa en ensamble. El esparcidor viene parcialmente posición vertical. Apriete las tuercas mariposa para fijarlo.
  • Page 3 H-2813 1-800-295-5510 uline.ca ÉPANDEUSE DE DÉVERGLAÇANT OUTIL REQUIS Pince INSTRUCTIONS REMARQUE : Lisez toutes les instructions Retirez l'épandeuse de l'emballage et dépliez la avant l'assemblage. Cette épandeuse est poignée en position verticale. Serrez les écrous à livrée partiellement assemblée. Des pinces oreilles pour fixer solidement.