Emtek Modern Brass Instructions D'installation page 10

How to Program
In order to perform each of the following six functions, the lock must first be placed in Programming Mode:
1. Press and hold EMTEK button for 3 seconds
2. Yellow LED flashes, then remains solid*
3. Enter Programming Code
If You Wish To
Change
Programming Code
(6 digits)
Add User Code
(4 digits)
(Store up to 20 User Codes)
Delete User Code
** Enable/Disable All User Codes
Delete All User Codes
Turn Beeper On/Off
*If no input within 10 seconds, Yellow LED goes out, Red LED flashes and lock exits Programming Mode.
**Also referred to as "vacation mode". This command temporarily disables all user codes (metal key override will still work).
Programming Your Lock
Press Button
Programming Code
1
2
3
4
5
6
4. Green LED flashes, then 2 beeps
5. Yellow LED remains solid
(awaiting button press; see following table)
Actions
Enter New Re-Enter New
Programming Code
(6 digits) (6 digits)
Enter New User Re-Enter New User
Code
(4 digits) (4 digits)
Enter User Code to Re-Enter User Code
be Deleted to be Deleted
Entering '4' disables all Users
(enables all if disabled)
Re-Enter Programming Code
Entering '6' turns OFF (or ON)
Indicators
• 1 Green LED flash
• 1 beep
• 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
• 1 Green LED flash
• 1 beep
• 1 Green LED flash
Code
• 1 beep
• 2 Green LED flashes
• 2 beeps
• 1 Green LED flash
• 1 beep
• 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
• 2 Green LED flashes
• 2 beeps
• 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
• 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps