Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS - RATIO AREA
G
G
NOTES:
For replacement LED Assemblies and Drivers please contact Current Lighting for any replacement parts.
Contact your local distributor or agent to confirm parts availability prior to ordering replacement parts.
701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000
SAVE THESE INSTRUCTIONS
ACCESS TO 1/2-13 HEX HEAD BOLT
LOOSEN TO ADJUST ANGLE
TIGHTEN TO 35 FT/LBS
H
E
AIM ARROW INDICATOR
ADJUSTMENT SLOT
ADJUSTMENT SCREWS
Ratio Area Knuckle Mount
Fixture Installation:
1.
Make power connections from the fixture wiring to the
power feed wires. Route the connected wiring into the
interior of the pole through the tenon.
2.
Attach the Knuckle to pole (E) by sliding the Knuckle
onto the tenon. Tighten each of the (4) 3/8-16 set
screws (G) using a 3/16 Allen wrench to approximately
12 ft-lbs.
Aim Adjustment:
1.
Determine the desired vertical aim angle before
attempting adjustments.
2.
Notice that there are tick marks are at 15° intervals, plus
long tick marks at 0°, 45° and 90°. The knuckle will
actually allow finer adjustments to 4° per step.
3.
Remove the center hub cover (H)
4.
Notice the large 1/2-13 hex head bolt in the center of the
hub acts as a pivot and should be loosened slightly for
adjustment, but never removed.
CAUTION: secure housing assembly or obtain help
holding and positioning the fixture while adjusting the
aim .
5.
Aim the fixture to the desired angle.
6.
Once the aim angle has been completed, tighten the
1/2-13 Hex Head pivot bolt to 35 ft-lbs.
7.
Replace the Knuckle cover (H).
Photocontrol Orientation
NOTE: A photocontrol is not included with this fixture.
This orientation procedure is only necessary if
adjustment is required to aim the photocontrol in a
certain direction. Otherwise, the photocontrol will
function properly with no adjustment required to the
photcontrol receptacle.
Angle Adjustment:
1.
Remove shorting cap or photocontrol if installed.
2.
Slightly loosen the two screws to allow rotation of the
center section of the receptacle.
3.
Insert a screwdriver tip into the adjustment slot located
in the center of the the receptacle and rotate so that the
arrow indicator points in the desired direction (usually
north)
4.
Sufficiently tighten two screws.
5.
Install photocontrol into receptacle, twist and lock into
position. Check to ensure photocontrol is pointing in
the desired direction.
www.beaconproducts.com
SHEET 3 O 4
PHOTOCONTROL
RECEPTACLE
LOCATION
Publicité
