Preparation For Use; Technical Data - Kiwi KK 3318 Mode D'emploi

PREPARATION FOR USE

1. Remove all packing from the kettle and its power base. Before using the kettle for
the first time, r if it has been out of use for a long time fill to the max mark and boil,
then discard the boiled water and rinse the kettle out with cold water.
2. Before connecting the appliance to the mains supply check that the voltage
indicated on the rating plate corresponds with the mains voltage in your home.
INSTRUCTIONS FOR USE
1. Always remove the kettle from the power base before filling.
2. Lift the lid.
3. Fill the kettle between the MIN and MAX marks on the water level indicator with
cold water.
4. Replace the lid and place the kettle back on the power base. Make sure the lid is
securely fitted on the kettle before boiling.
5. Position the kettle on the power base.
6. Plug the power base into the power outlet and switch on at the mains.
7. To start boiling press the ON/OFF switch to the down position.
8. The power indicator will illuminate and the kettle will start to boil. NEVER REMOVE
THE LID DURING BOILING.
9. When the water has boiled the kettle will switch off automatically and the power
indicator will extinguish.
10. You can stop the boiling process at any time by pressing the switch to the OFF
position.
11. After the kettle has switched off automatically, there may be a short delay before
it can be re-boiled. This is usually no more than 20 seconds.
12. The safety cut-out will operate if you accidently switch on the kettle when it is
empty or allow it to boil dry Wait 15 minutes for the cut-out to reset before refilling
with cold water and boiling.
CLEANING
1. Always unplug the kettle from the mains supply and allow to cool down completely
before storing or cleaning.
2. Never immerse any part of the power cable, plug, power base or kettle in water or
any other liquid.
3. Wipe the exterior of the kettle using a damp cloth. Dry thoroughly. Never use harsh
chemicals or abrasive cleaning agents as these may damage the finish of your kettle.
4. Over a period of time lime scale can build up inside your kettle. To remove lime
scale half fill the kettle with water and add the juice of a lemon. Boil the kettle and
allow to stand for 15 minutes before discarding. Repeat several times using cold
water only. Safety, as insertion into a 13 amp socket could cause an electrical hazard.

TECHNICAL DATA

Rated Voltage: AC230V, 50Hz Power: 1850-2200W Capacity: 1.7L
KK 3318 User Manual
5