Troubleshooting Guide - UFESA FLEXY-HEAT NC COMPLEX Mode D'emploi

INSTRUCTIONS FOR USE
Prior to connecting the product to the mains, check your power supply voltage to ensure it is
the same as the one indicated on the label included on the product. Connect the product to
the appropriate mains.
In order to turn on the product, you must select the slider switch on the control, setting it to
position 1, 2 or 3 (Fig.1).
From this time on, the product is operational.
The maximum operation time is 90 minutes, after which the automatic safety shut-down
will immediately activate. The product will no longer heat up when in this state.
To turn on the product again, set it to position "0" and select the desired temperature.
Select the "0" position in order to turn off the product before you disconnect the device from
the mains.
The pad models NC and NCD have been specially designed as an effective system to relax
the muscles of the neck and cervical vertebrae (NC), as well as the muscles of the upper part
of the back and dorsal vertebrae (NCD) which are the areas most frequently subjected to
muscular tension.
The NC model sits around the rear of the neck, adjusting the fix button on the product, so
that it sits approximately under the chin (Fig. 2). The NCD model is placed at the top of the
back just like the previous model. Its lower section adapts to the waist, and the snap lock
can be adjusted in advance to the required length to be placed around the navel area. (Fig. 3)
The lumbar-menstrual pad has an ambivalent design especially adapted for the application
of heat in the abdominal area and the lumbar region. The LM model is positioned by adjusting
the product to the lumbar area using the velcro system (Fig. 4).

TROUBLESHOOTING GUIDE

Possible operational problems
PROBLEM
The regulator control does not light up when
After a certain operation time, the product
temperature seems to reduce.
RECOMMENDATION
Ensure that the regulator is properly connected
to the pro- duct and that there is voltage in the
socket of the mains used and that the product is
properly plugged in.
The product has an auto-stop system that
activates after 90 minutes of continuous
operation. After this time, the light on the
regulator starts to flash. If you want to continue
to use it, change the temperature level to level 0,
wait a few seconds, and then select the desired
temperature.
17