Installing The Crossover - Orion Cobalt CO552 Mode D'emploi

step 5: Install tweeter in flush mount housing .
step 6: Connect the speaker wires observing the correct polarity .
step 7: Install tweeter and housing in the hole cut for mounting, so that the trim ring is flat
with the front of the surface .
step 8: use the supplied pressure ring to secure the housing to the surface .
figure 5
figura 5
abbildung 5

InsTallInG THe CRossoVeR

step : find a location for the crossover away from any factory or after market electrical wires .
It is recommended to mount the passive crossover close to the amplifier .
step 2: Mount the crossover using the supplied wire ties .
step 3: Connect the wires . Make sure the speaker wires for the midrange go to the mid/
woofer output and the tweeter to the tweeter output . be sure to observe the correct
polarity . Changing the polarity of the tweeter may be necessary for optimum sound
quality .
6
Flush Mount
Tweeter
Assembly
Flush Mount
Trim Ring
Mid/Woofer
Wire
Tweeter
Cup
Tweeter
Wire
Panel
Panel
© 2007 directed electronics—all rights reserved
Pressure
Ring
Wiring
Harness
Wiring
Harness