AENO RC2S Manuel De L'utilisateur page 10

place the device where it can easily fall down from (tables, chairs, stairs, high
platforms, etc.).
The vacuum cleaner has several sensors: a lidar located on the surface of
the body of the vacuum cleaner and the sensors on the bumper . Do not
allow foreign objects to fall on the sensors. During cleaning, make sure children
and the elderly are safe to avoid injuries. If the body of the vacuum cleaner gets
too hot while charging, stop charging it. Do not use the vacuum cleaner battery
with other devices. Do not short-circuit or disassemble the battery.
Power off the device if it has been idle for a while. The vacuum cleaner must be
on and charged at all times to operate on a schedule.
Charge before operation
Remove the protective plugs from the body of the vacuum cleaner (see figure
b) before operation. Fit the side brushes to the device (see figure c).
Connect the docking station to a power outlet using the power adapter
(see figure d). Insert the power adapter plug into a power outlet and the power
adapter connector into the socket on the body of the docking station. Hold
the vacuum cleaner by its body and align the contacts on its bottom
between the side brushes with the contacts on the docking station . If the
robot vacuum cleaner is positioned correctly, the LED on the docking station
and the recharge icon on Robot will blink. Once the charge is complete, the
recharge icon on Robot will always be on. The first charge from the docking
station should last for 6.5 hours.
WARNING! The docking station must be placed by the wall (see figure d).
Remove all objects within 0.5 meters to the left and right of the station and 1.5
meters in front of it.
aeno.com/documents 10