CAPITAL SPORTS Kaelua All-Rounder Mode D'emploi page 19

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Board Deflation Steps
1. Clear any water or debris out of the valve areas.
2. Slowly press down on the valve stem to start letting air out of the board.
There will be an initial burst of air, but that will slow down very quickly.
Once the air flow has slowed down, press the valve stem all the way down
and turn it clockwise to lock it into the "open" position.
Center Fin Installation
1
Shift the bracket to the front of the fin
box. Use the screw to help guide the
bracket if required.
3
Push the fin down and align the
screw hole at the front of the fin with
the screw hole in the bracket. The fin
edge may be sharp, handle carefully.
2
Ensure the fin pin is centered and
insert into the fin box, push the pin
towards the rear of the fin box.
4
Fix the fin in place by inserting the
screw through the hole in the fin to
the bracket. Tighten the screw and
ensure the fin is secure.
EN
19

Publicité

Table des Matières
loading

Table des Matières