Teleco TVDAYA01 Serie Mode D'emploi page 9

14.3 REMOTE MEMORIZATION OF OTHER RADIO CODES FROM STANDARD TRANSMITTER
Note: The button P3 is located inside the standard transmitter. The added radio code will have the same functions as the code used for memorization.
This procedure is compatible with any type of transmitter.
Memorized
P3
Standard transmitter
Press button P3 of the memorized standard transmitter and hold. The buzzer emits a continuous sound. Press
a button relative to an already memorized code. The buzzer stops for 1 second and then starts the continuous
sound again. Press the virtual button on the Daisy transmitter relative to the new code to be memorized. Successful
memorization is indicated by the intermittent sound of the buzzer.
15.0 SENDING SCENARIO
1. Tap (Scenario
icon) to enter in the
next menu.
16.0 RESET WI-FI NETWORK CONFIGURATION
Button: Reset Wi-Fi
Network configuration (*)
* The memorized transmitters are not deleted.
Press (P) once and hold for 5s:
Blue
...
(5 s)
Alternatively hold the button (P) down and at the same time turn on the power:
ON
Memorized
continuous
sound
< 5 s 1 s
i
Scenario
2. Tap (Scenario
i c o n ) t o s e n d
scenario.
Blue Red
Blue Red
Red
1 s 1 s 1 s 1 s 1 s 1 s
Blue Red Blue
...
0.5 s 0.5 s 0.5 s
0.5 s
New
continuous
Daisy transmitter
sound
< 5 s
Daisy
Send Scenario
No Yes
3. Tap (Yes) to
send scenario.
...
Red Blue Red Blue Red
...
0.5 s
0.5 s
i
Scenario
Note: Tap (i) icon to get information
about the scenario set.
... ...
...
Light 1 (ON)
Fan (LEV2)
Screens (CLOSE)
Blue Blue
...
0.5 s 0.5 s