Commissioning; Operation - monzana MZH2000 Guide D'introduction

Installation positions:
Install heater horizontally (max. 5° deviation).
wrong

5.3 COMMISSIONING

•
Plug the power cord into the power outlet.
•
Set the on/off switch on the unit to position "1".
•
The LED display on the device will light up red.
•
The device is now in standby mode.

6.0 OPERATION

Inserting the batteries
•
Turn the remote control to the back and pull out the battery cover. Insert the batteries
according to the instructions and the polarity (+/-) of the batteries.
•
Insert 1 x type CR2025 batterie into your remote control.
•
Replace used batteries as described above.
Attention!
Please use the battery type specified in this manual. Improper or incorrect use of the batteries
may cause corrosion or battery leakage, resulting in personal injury or property damage.
Observe the specified minimum distances when mounting.
wrong
18
correct
www.DEUBAXXL.de