Publicité
Les langues disponibles
Les langues disponibles
INSTALL INSTRUCTIONS
VERSARAC
STEP 10
Place two angle posts together to create
one upright angle post. The angle post
that attaches to the ceiling mounting angle
should be on the outside. The widest part of
the keyholes should be facing up on both
pieces. Slide the pieces until you get your
desired overall length. Bolt 2 angle posts
together using the ¼" dia. x ¾" long bolts,
washers and nuts provided. Use 2 washers,
one between the bolt head and angle post
and one between the nut and angle post.
Place one bolt on each side of the upright
angle. See figure 2. Tighten both bolts.
Figure 2
STEP 11
Repeat step 7 to form the other 3 angle
posts. Make sure all 4 angle posts are the
same length.
STEP 12
Bolt angle posts to ceiling angle brackets
you have already installed. Use the ¼" dia.
x ¾" long bolts, washers and nuts. Use 2
washers, one between the bolt head and
angle post and one between the nut and
angle post. See figure 3.
Figure 3
?
need more information
try
STEP 13
Drop the cross beams into the vertical angle
posts. Start with the short beams first, then
the long beams. The 1" wide flange on the
cross beam goes on top. The rivet nubs
on the cross beams go into the keyholes
on the vertical posts. Tap the cross beams
into place using a rubber mallet to seat the
beams into the upright posts. The rivet
nubs should go all the way to the bottom of
the keyholes. See figure 4. If ceiling mount
angles move when you tap down the cross
beams, the ceiling angles are not tight or
are not bolted into sufficient structure.
Opposite ends may become loose when
hammering the beams in place, care must
be taken to watch for a beam that may
fall out during this process. Use a helper
to ensure all nubs are securely locked into
the keyholes. Double check ceiling lag bolts
to make sure they are tight and securely
fastened to the supports. If there is not
sufficient structure, remove brackets and
find the proper ceiling support.
Figure 4
STEP 14
Find the holes in the middle of the long cross
beams. Install the Center Support into these
holes with the remaining nuts and bolts.
, WWW.NEWAGEPRODUCTS.COM
STEP 15
Place Steel Grid Platforms with the flange
overhanging the cross beams on either
side of the width of the rack frame.
STEP 16
Periodically (at least quarterly) inspect
your VERSARAC unit to ensure beams are
seated properly and brackets are firmly
connected to the overhead supports and
securely fastened to the supports. If there
is not sufficient structure, remove brackets
and find the proper ceiling support.
For specific questions regarding: product
installation, care, or cleaning, please
contact Customer Service at NewAge
Products
1 877 306 8930
or
for answers to commonly asked questions
.
Publicité
