PUTCO 470100 Instructions De Montage

HOOD SHIELD INSTALLATION INSTRUCTIONS
Congratulations on your purchase of a high quality PUTCO product. Should you need
any application or technical assistance feel free to call us at: 1-800-247-3974
Monday-Friday 8:00 a.m. - 5:00 p.m. (Central Standard Time)
Contact your PUTCO dealer for other quality accessories.
Please read all instructions before installation and to check to see that all parts are included.
Kit Contents:
Description
Hood Shield
10-32 Well Nut (A)
10-32 Philips Bolt (B)
3/16 Flat Washer (C)
Rubber Bump-on
Note: Rubber Bump-on is required for
this application to prevent damage
to the hood.
• Installation Temperature:
60º - 110º F (16º - 43º C)
1. Clean and open the hood. Make sure that
the hood is free of any dirt or debris.
2. Trial fit Hood Shield by aligning the
mounting holes of the Hood Shield with the
matching holes in the hood. (Figure 1)
3. Attach supplied hardware to hood shield. (Figure 2)
4. Re-fit Hood Shield to the factory hood by aligning the rubber well nuts up
with the factory slots. (Figure 1) Attach Hood Shield to the vehicle by
installing the center mounting point first and working outwards. Tighten
screws just enough to hold hood shield in place.
5. Center Hood Shield on the hood and tighten screws using a Philips screw
driver until snug. Close hood carefully to check the fitment. If the Hood Shield
is not centered loosen the screws and adjust until it is centered and re-tighten
the screws.
6. Attach rubber bump-on to the factory hood where the corners of the Hood
Shield are closest to the hood. (Figure 3) Clean area first with isopropyl
alcohol and remove adhesive backing from bump-on and apply to the
hood.
LIMITED 1 YEAR WARRANTY
Putco guarantees it's Stainless Steel and Aluminum products against defects in workmanship and material for as long as you own
your vehicle. All painted products have a 90 day warranty on the painted surface. Any defects resulting from faulty material or
workmanship will be warranted by Putco and repaired or replaced at our discretion. Putco assumes no extra labor costs. Damages
caused by freight carriers, improper installation, misuse, collision, or neglect will not be warranted by Putco. Putco is not liable for
any vehicle damage resulting from the installation of our Hood Shield.
www.putco.com
Qty.
1
A
3
3
3
2
Figure 1
2/25/2013
470100 & 570100
2007-2013 Silverado LD
B C
Figure 2
A
B
Figure 3
on
Bump-
Page 1 of 3
C