Beamz Pro HZ3000 Mode D'emploi page 5

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and have been
received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from shipping or the
package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be returned to the factory, it
is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation
water might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this,
all other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be
used. No dimmer or adjustable power supply.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to avoid the
risk of electrocution or fire.
Step 1: Place the unit on a flat surface and in a suitably large area with at least 50 cm of open space around the unit.
Step 2: Fill the fluid tank with Beamz oil based haze fluid.
Step 3: Connect the machine to a suitably rated power supply. To determine the power requirement for the unit refer
to the label on the back of the unit.
Step 4: Turn on the unit, put the power switch to the "ON" position.. The LCD display will show "WARMING UP". After
few seconds the LCD display will shows "READY".
Step 5: To start producing haze, press "LOCK" on screen then select output level "UP" or "DOWN". To stop producing haze
press again "LOCK".
Step 6: Turn off the unit, put the power switch to the "OFF" position.
Step 7: Before transporting the unit, empty the fluid tank by connecting a tube to the valve.
Use only original Beamz oil based haze fluid! (Beamz reference 160.674, 160.669, 160.668 and 160.673). Warranty will
be voided if any other type of liquid is used, improper use of liquid may lead to machine failure and malfunction.
When display shows "READY", you can start producing haze and adjust the settings via LCD display panel.
Menu Description
DMX512 Set DMX start address
Interval 00 min 01 sec - 59 min 59 sec
Duration 00 min 01 sec - 59 min 59 sec
Timer Setting timer function, press up and down
Volume Setting haze volume, press up and down
Fan Fan speed 20 - 100%
DMX 001-253
Manual Manual test button
Remote Switch remote control function ON - OFF
W IRELESS REMOTE
A: ON / OFF
B: ON / OFF
C: Output volume up
D: Output volume down