Publicité
Les langues disponibles
Les langues disponibles
HOW TO PERFORM A CABLE TEST
Press the red power button
• Connect a network cable to the CableMaster 800/850 then connect a Network/Telephone
testing remote to the opposite end of the cable. From the home screen, press the enter
button or cable test soft key
automatically perform a test upon entering the cable test menu.
• To test coax cable, connect a coax cable to the CableMaster 800/850, then press the coax soft
key
.
• To test telephone cable, connect the CableMaster 800/850 to a telephone cable using RJ12 patch
cable, press the coax soft key
• If a remote is NOT being used (one ended test), the CableMaster 800/850 will test the length of
each pair, opens, shorts, or split pairs. Performing a one ended test will not verify connectivity on
the opposite end of the cable.
• To calibrate the VoP, connect a known length of cable to the CableMaster 800/850 and press the
up/down/left/right buttons to increase or decrease the VoP. Press the left and right buttons to
select and change the VoP one digit at a time.
• While adjusting the VoP, press the test button until the desired length of the cable is displayed.
• To save the calibrated VoP, go to the Setup
key (note: your adjusted VoP will be displayed next to the RJ45 or Coax icon). See page 3 for
Setup instructions.
• Press the green test button tests
.
• To save a cable test, press the save soft key
• Use the arrow buttons and the enter button to name the cable test file.
• Press the Save soft key again to save the test file
HOW TO PERFORM A PORT DISCOVERY
TEST NETWORK/POE TEST
• Connect the CableMaster 800/850 to a switch or active network jack.
• From the home screen, use the right arrow button to select the Network/PoE icon and press
the enter button or press the Network/PoE soft key
• The CableMaster 800/850 will automatically detect and display link capability, connection speed,
PoE mode, and PoE Min/Max voltages.
• To perform a Network Test only, press the PoE off soft key
• To save the PoE data, press the Save soft key
• Use the arrow buttons and the enter button to name the PoE file.
• Press the Save soft key to save the PoE file
to turn the CableMaster 800/850 on
to display the cable test menu. The CableMaster 800/850 will
then the
telephone soft key.
6 T3 Innovation 33 and press the Save
or the loop mode soft key
.
.
.
.
to perform additional tests
.
.
soft
3
Publicité
