Motorline professional TEC1 Manuel De L'utilisateur page 9

-receiver channel 1 if the user presses
-receiver channel 2 if the user presses
The command will be transmitted only when a valid combination has been entered: if an incorrect
combination has been entered the selector will emit an error, warning signal when the confirm key is
pressed . The combination entered must be exact, if, for example ,the correct combination is 0422, the
following attempts will be interpreted as errors: 422, 10422, 04222. Therefore, if the user inadvertently
presses the wrong key when entering a combination, combination key
immediately to generate the error tone , after which the correct combination can be entered starting
from the beginning again.
While entering the combination no more than 6 seconds can be allowed to elapse between keystrokes,
after which interval the combination must be re-entered starting from the beginning.
The units are factory programmed with a standard combination to activate channel one and a standard
combination for channel two.
The factory set combinations are as follows:
- 1ª combination to transmit the code associated with the
When the unit is used for the first time this combination is 11
- 2ª combination to transmit the code associated with the
When the unit is used for the first time this combination is 22.
15) Changing a combination
Tab.A changing the combination associated with channel 1
This function allows you to change the combination associated with channel 1
1.Press the "0" key and hold it down while pressing and releasing
2.Release the "0"key
3.Type in the current (original) combination ans press
4.Type in the new combination (up to 8 digits ) and press
5.Type in the new combination again and press
Tab. B changing the combination associated with channel 2
This function allows you to change the combination associated with channel 2
1.Press the "0" key and hold it down while pressing and releasing
2.Release the "0"key
3.Type in the current (original) combination and press
4.Type in the new combination (up to 8 digits ) and press
5.Type in the new combination again and press
.
key.
key.
or should be pressed
9