RC Lighting ALED3T105N Directives D'installation

®
ALED 50W -150W WITH UNIVERSAL ARM INSTRUCTIONS
Thank you for buying RC lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments. Call the Marketing
Department at 888-722-1000 or email: marketing@rclighting.ca
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RC fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. This product must be installed in accordance with the applicable installation code by a person familiar with the
construction and operation of the product and the hazards involved.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
MOUNTING THE UNIVERSAL ARM ON
THE FIXTURE
1. Remove the Arm Cover from the Arm.
2. Feed wires from Fixture through Gasket into Arm.
3. Line up Arm and Fixture. Place flat washers, lock washers
and nuts on the Short 3/8-16 bolts inside the Arm and
tighten securely to housing.
4. Make sure the Gasket is secure between Arm and
Fixture.
SQUARE POLE BRACKET MOUNT
1. Remove Round pole adaptor and RPA gasket.
2. Place the Bolster plate inside the pole..
3. Place the bracket to match the holes on the pole
4. Feed supply wires from the pole through the Bracket to
be connected to the Arm.
3. Place flat washers, lock washers and nuts on the Short
3/8-16 bolts tighten to the pole.
ROUND POLE BRACKET MOUNT
1. Place Round Pole Adaptor (RPA) and RPA Gasket
between the fixture and drilled Pole as shown in Fig.3.
2. Line up the holes of the Gaskets and Round Pole
Adaptor with top hole in the pole drilling pattern.
3. Feed supply wires from the pole through the Bracket to
be connected to the Arm.
4. Place long 3/8" Bolts provided through the top hole
of the RPA and Gaskets to the Round Pole thread into
Bolster Plate.
ALED with Universal Arm
Arm
Arm Gasket
Bolster Plate
Bolster Plate
Round Pole
Short 3/8-16
bolts
Arm Cover
3/16" allen
screw
Square Pole
FIG.2
RPA Gasket
Round Pole Adaptor(RPA)
FIG.3
Gasket
Fixture
FIG. 1
Short 3/8" bolts
Bracket
Long 3/8" bolts