RAB Design GWL-LED Instructions D'installation

GWL-LED
INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
WARNING
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.
SAFETY
Proper grounding is required to ensure personal safety

Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.

Do not use this equipment for anything other than its intended purpose.

Servicing this equipment should be performed by qualified service personnel.

Save these instructions

INSTALLATION
 Separate the LED fixture from its housing by loosening the
Phillips Head screw(s) located below the lens
Mount the fixture housing onto the junction box

The GWL-LED is designed to temporarily hook and secure

itself on top of the housing for ease of wiring (Fig 1)
Make appropriate wiring connections (Fig 2)

a. Check that the line voltage is correct and connect
fixture GROUND (green) to power supply GROUND
wire
b. Connect fixture WHITE wire to power supply
NEUTRAL wire
c. Connect fixture BLACK wire to power supply HOT
wire
Unhook fixture from the housing, flip over and reattach

fixture to the housing (Fig 3)
Push fixture against housing and tighten Phillips Head

screw(s) located below the lens (Fig 4)
RAB DESIGN LIGHTING INC.
READ, UNDERSTAND
before installing the equipment.
Fig 1
Fig 2
Fig 3
www.rabdesign.ca
FOLLOW
, and these instructions
Fig 4
1