Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

SBL6-LED
INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
WARNING
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.
SAFETY
Proper grounding is required to ensure personal safety.
Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.
Do not use this equipment for anything other than its intended purpose.
Servicing this equipment should be performed by qualified service personnel.
Save these instructions.
MIN 90 °C SUPPLY CONDUCTOR
INSTALLATION
Tools Required: Adjustable Wrench
Surface Mount
1.
Separate the bollard shaft and the base by loosening the screws at the
bottom using provided Allen key
2.
Assemble the anchor bolt carrier and place the anchor bolts in concrete by
having at least 1-1/2 ~2" protruding from concrete with threads free and clear
of debris and dirt
3.
Place bollard base over anchor bolts and tighten nuts to secure the base.
4.
Make wire connection as per wiring diagram at the 5 Port Terminal Block on
the support bracket.
5.
Reattach the bollard shaft to the base and tighten the set screws.
CCT Select and Power Select:
1.
Separate the bollard head and the shaft by loosening the set screws using
provided Allen key
2.
Select the desired CCT and Power by adjusting the DIP switches. The CCT
selectable switch can be set to 3000K, 4000K, and 5000K CCT. The power
select can be set to 12W,16W and 22W. The default settings are 22W and
5000K.
3.
Reattach the bollard head and shaft by tight the set screws.
RAB Design Lighting inc.
READ, UNDERSTAND
before installing the equipment.
May – 2022
FOLLOW
, and
these instructions
Page 1 of 2

Publicité

loading

Sommaire des Matières pour RAB Design SBL6-LED

  • Page 1 3000K, 4000K, and 5000K CCT. The power select can be set to 12W,16W and 22W. The default settings are 22W and 5000K. Reattach the bollard head and shaft by tight the set screws. RAB Design Lighting inc. May – 2022 Page 1 of 2...
  • Page 2 Connect fixture BLACK wire to power supply LINE wire • The fixture includes 0-10V dimming functionality, connect GREY or PINK and VIOLET wires to a 0-10V dimming controller (optional). RAB Design Lighting inc. May – 2022 Page 2 of 2...
  • Page 3 5000K. La sélection de la puissance peut être réglée sur 12W, 16W et 22W. Les paramètres standards sont 22W et 5000K. Remettre en place la tête de la borne et la colonne en serrant les vis de réglage. RAB Design Lighting inc. MaI – 2022 Page 1 de 2...
  • Page 4 Branchez le fil NOIR du luminaire au fil de LIGNE de l'alimentation. • Le luminaire inclut une fonction d’intensité réglable de 0-10V, branchez les fils GRIS ou ROSE et VIOLET à un contrôleur de 0-10V (optionnel). RAB Design Lighting inc. MaI – 2022 Page 2 de 2...