Princeton Tec BYTE Mode D'emploi

Battery Installation
– See Battery Installation Diagram
• 2 AAA
• Alkaline (LR03) or Lithium
• Rechargeable NiCad or NiMH
Princeton Tec cares about the environment and
recommends recycling batteries. For more information
about battery recycling, please
batteryrecycling.com
To install the batteries, unlatch the battery door. Open
the Byte case by popping the door latch over the catch
and rotate the door open.
Install two AAA batteries as shown in the diagram.
The tall spring on the battery door should correspond
with the negative polarity and the shorter spring on
the battery door should correspond with the positive
polarity. Observe proper battery polarity when installing
the batteries. Improper installation of the batteries will
damage the light and void the warranty.
Rotate the door to the closed position, squeeze the body
between your forefingers and thumb to snap the door
latch over the catch.
!
WARNING
• Never mix fresh and used batteries.
• Never mix different battery brands or
chemistry types.
• Always remove drained batteries immediately.
• Remove batteries during long periods of storage.
NOTE: Rechargeable NiCad or NiMH batteries may
result in reduced brightness due to lower nominal
voltage.
Switch Operation
– See Switch Operation diagram
The Byte has two light sources to choose from: one
3mm Red LED and one Maxbright white LED. The Red
LED always turns on first, followed by the Maxbright
LED in low mode, then high mode.
To turn the light on or switch to the Maxbright LED
modes, press and release the power button until the
desired mode is obtained.
A single press more than 1.6 seconds after the previous
button press will turn light off.
*The times listed on the rear of the package assume
beginning with fresh batteries and only using one mode
Byte is equipped with a battery lockout to prevent
accidental activation.
Press 5 seconds: Lock-Out
Press 5 seconds: from Lock: Unlock.
Troubleshooting
If the Byte fails to light: .
• Check the batteries for proper installation.
• Replace batteries if proper installation is confirmed.
• Check the light for water contamination.The light
Figure 1 – Battery Replacement
1
Figure 2 - Switch Operation
go to: www.
• Princeton Tec calculates total burn time as the time it takes for the light source to produce a minimum of 0.25 lux
at 2 meters. 0.25 lux is about the equivalent of a full moon on a clear night.
• Princeton Tec berechnet die Gesamtbrenndauer bezogen auf eine von der Stirnlampe erzeugte minimale
Beleuchtungsstärke von 0,25 Lux in 2 Meter Abstand. 0,25 Lux entsprechen in etwa der Beleuchtungsstärke des
Vollmonds in einer klaren Nacht.
• Princeton Tec définit la durée totale d'éclairage comme le temps nécessaire à la sourc umineuse pour produire
un minimum de 0,25 ux à 2 mètres. 0,25 lux équivaut à peu près à laluminosité d'une pleine lune dans un ciel
nocturne dégagé.
will resume normal operation once the water is
shaken or blown out and the light is left open until
completely dry. If the light has been contaminated
with salt water, flush the unit with fresh water and
dry as described above.
USA– International 5-Year Warranty
WARRANTY – Princeton Tec warrants this product to
be free from defects in workmanship and materials
under normal use for 5 years. This warranty covers all
of the component parts of the product except batteries.
This warranty does not cover deterioration due to
normal wear or damage due to misuse, alteration,
negligence, accidents, or unauthorized repair. Princeton
Tec will repair or replace parts which are defective in
workmanship or materials.
Your authorized Princeton Tec Dealer and Princeton Tec
are the only facilities authorized to repair the product.
After (3) unsuccessful attempts (within the warranty
period) to repair the product, you have the right to
elect replacement of the product or a refund of the
purchase price less allowance for use of the product.
NO INCIDENTAL OR CONSEQUENTIAL DAMAGES
ARE INCLUDED IN THIS WARRANTY. (Some states
do not allow the exclusion or limitation of incidental
or consequential damages, so the above limitations or
exclusions may not apply to you.) This warranty gives
you specific legal rights, and you may also have other
rights which vary from state to state.
Princeton Tec reserves the right to change product
specifications without notice.
Remplacement des piles
2
Modes de fonctionnement
Press 1x: Red
RED
Appuyer 1x: Rouge
1 x drücken: Rotes
Press 2x: White Flood 50%
Appuyer 2x: Projecteur blanc à 50%
2 x drücken: Weißer Breitstrahler bei 50%
Press 3x: White Spot 100%
Appuyer 3x: Spot blanc à 100 %
3 x drücken: Weißes Spotlicht bei 100 %
3 MODES
Total burntime 3 H
SPOT HIGH
80 H
SPOT LOW
RED
100 H
DISTANCE
0 3
(METERS)
Batteriewechsel
3 4
Schalterbetätigung
Press 1x from On: Off
Appuyer 1x lampe allumée : Extinction
In eingeschalt. Zust. 1 x drücken: Aus
Press 5 seconds: Lock-Out
Appuyer 5 secondes lampe éteinte: Verrouillage
In ausgeschalt. Zust. 5 Sekunden drücken: Sperre aktivieren
Press 5 seconds from Lock: Unlock
Appuyer 5 secondes lampe verrouillée: Déverrouillage
In gesperrtem Zust. 5 Sekunden drücken: Sperre deaktivieren
BEAM DISTANCE
48 m
46 m
24 m 21 m
3 m 2 m
24 48
0 H 0.5 H
T= Time/ Zeit/ Temps
FOR CALIFORNIA RESIDENTS:
WARNING: This product contains Bisphenol A (BpA) a
chemical known to the State of California to cause birth
defects or other reproductive harm.
Return Policy
If your light fails to operate, follow these simple steps:
1. Check batteries. Replace if necessary.
2. To send your light in for repair or replacement,
first contact Princeton Tec customer service on
1-800-257-9080 to request an RMA number. Please
have your light model, date of purchase and a brief
description of the fault you are experiencing. No
warranty repairs will be accepted without an RMA
number.
3. Return the light without batteries to: Princeton Tec,
PO Box 8057 Trenton NJ 08650. Postage due and
freight collect items will not be accepted.
4. Upon receipt your light will be processed in about
two weeks. Please allow additional time for return
transportation from NJ
Princeton Tec
PO Box 8057,
Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
princetontec.com
© 2018 Princeton Tec
0 m
8 m
1 m
10 H