Selecting A Location - STACK-ON GCM-1918-DX Manuel D'instructions

Side By Side Shelf Assembly
To assemble two shelves at the same height, assemble the shelves as
shown. It is important to note that you will be using the same screw to
support both shelves through the Center Partition.
towards the right side. We recommend not tightening the screws until
both your shelves are in place.
as described later in these instruction.

SELECTING A LOCATION

optimal safety and security, the cabinet should be installed adjacent
to the side wall of a closet with minimal space on either side of the
Remove the baseboard if necessary.
THE CABINET SHOULD ALWAYS BE KEPT OUT OF
THE REACH OF CHILDREN.
CENTERS
CABINET
TOP VIEW
MINIMUN
16"
SECURING THE CABINET
Before you install the cabinet to a wall and the floor, install
the interior components as described in the assembly
instructions.
NOTE: This cabinet must be mounted to wall studs and the
floor. Failure to do so will compromise the safety and
security of the cabinet.
NOTE: The cabinet must be secured to wall studs in the top
holes in the back of the cabinet so that it is anchored to the
wall studs in two locations. The cabinet must also be
mounted to the floor. Consult your hardware retailer for
fastening hardware for your particular mounting surfaces
Insert the plastic plugs in the cabinet's top mounting holes if you
are not installing the a Pistol-Ammo cabinet on the top of the
security cabinet.
4
18
40864-2207