Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RX545i
Connecting washer parts
Fig.1
Fig.3
The washer has a side mounted holster which holds
the gun / lance neatly in place for storage. This is
assembled by sliding the top clasp (fig. 2) onto the
mounting point (fig. 1)
A lower retainer holds the end of the gun / lance
securely. This is attached by sliding the lower cup
(fig. 4) onto the mounting point at the base of the
washer (fig. 3)
A
Fig.5
The front lower handle provides a convenient point to
grip when transporting your washer and also serves
as additional stability when upright. To attach, insert
the handle 'A' into the sockets 'B' at the lower front of
the machine. Fix in place on the under-side with the
two screws provided.
Fig.2
Fig.4
A
B
B
Fig.6
En
Hints for getting started
Automatic On / Off:
The motor on this pressure washer does not run
continuously. It only runs when the trigger of the spray
gun is squeezed.
Bleeding the gun:
It is very important to bleed the gun before and after
using the pressure washer.
Squeeze the trigger to allow any air that is trapped
inside of the unit and hose to escape. Continue to
squeeze the trigger until a steady stream of water
comes from the nozzle. (This process may take up to
2 minutes).
This will prevent freezing in cold temperatures and
damage to the machine and the gun.
© Wilks-USA
4
Publicité
Table des Matières
