Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
MINI PISTOL GRIP
GREASE GUN
OPERATING INSTRUCTIONS
1.
2.
3.
4.
3 OZ. GREASE GUN LOADING
1. Pull plunger back & lock in place.
This helps seal the unit to prevent
leakage and contamination.
2. Remove grease gun head, remove
plastic cap from cartridge, and
insert face down into gun.
3. With cartridge inserted, removed
pull tab / flip top from exposed
end of cartridge, and replace the
grease gun head.
4. Release the plunger lock, and
pump lever handle several times
to prime grease gun.
**Air bleeder valves help remove air
pockets from inside of cartridge, and
assist in priming the gun easier.
SUCTION FILLING
1. Remove grease gun head, and
submerge the open end into the
bucket of grease.
2. Hold the gun firmly and securely,
and slowly draw the plunger back
to fill the gun.
3. Watch for the groove in the
plunger rod to indicate the gun
is full, and then lock the plunger
rod in place.
4. Replace the grease gun head
back onto the gun and release
the plunger lock.
**Always keep the open end of the
barrel submerged while drawing on
the plunger to ensure no air gets
sucked into the gun.
Publicité
Sommaire des Matières pour BE Ag & Industrial MINI PISTOL GRIP
- Page 1 MINI PISTOL GRIP GREASE GUN OPERATING INSTRUCTIONS 3 OZ. GREASE GUN LOADING 1. Pull plunger back & lock in place. This helps seal the unit to prevent leakage and contamination. 2. Remove grease gun head, remove plastic cap from cartridge, and insert face down into gun.
- Page 2 WARRANTY INFORMATION TWO YEARS LIMITED WARRANTY For a period of two (2) years from your purchase date, BE AG & INDUSTRIAL will repair or replace (at its option) without charge, your BE AG & INDUSTRIAL product if it was purchased new and the product has failed due to a defect in material or workmanship which you experienced during normal use of the product.
- Page 3 PISTOLET À GRAISSE À POIGNÉE PISTOLET MODE D’ EMPLOI CHARGEMENT DU PISTOLET GRASISSEUR DE 3 OZ 1. Tirer le piston vers I’arrière et le verrouiller en place. Cela permet de sceller I’unité pour éviter les fuites et la contamination. 2. Retirer la tête du pistolet graisseur, enlever le bouchon en plastique de la cartouche et I’insérer face vers le bas dans le pistolet.
- Page 4 INFORMATIONS DE GARANTIE GARANTIE LIMITÉE DE DEUX ANS Pendant une période de deux (2) ans à compter de votre date d’achat, BE AG & INDUSTRIAL réparera ou remplacera (à son choix) sans frais votre produit BE AG & INDUSTRIAL s’il a été acheté neuf et que le produit a échoué...