Tekonsha 3081 Directives De Montage

Installation Instructions
Directives de Montage
Instrucciones de Instalación
Brake Control Plug
Bouchon de Commande de Frein
Tapón de control de frenos
Hyundai Palisade /
Kia Telluride
WARNING
ALWAYS read and follow all warnings and
instructions included with purchase before
beginning installation. Keep for future reference.
DO NOT exceed lower of towing manufacturing
rating (including in your vehicle owner's manual)
or specific amperage ratings stated on product.
ALWAYS read, understand and follow all
warnings and instructions printed on tow
vehicle's battery.
ALWAYS wear safety glasses and use all safety
precautions during installation.
3081-037 Rev. A
ENGLISH
TOOLS REQUIRED:
Trim Panel Remover, Test-probe
1. Locate the vehicle's electric brake control harness
connector. Remove the driver's side kick panel.
There will be a 4-pin connector that mates with
the brake control harness taped to another vehicle
harness. Connect the brake control harness into
the vehicles connector being careful to not break
A
locking tabs.
2. Plug the brake control adapter into the vehicle
electric controller connector.
3. Complete the installation per the electric brake
control manufacturer's instructions and mount
the unit as directed. Perform test procedures as
instructed.
NOTE: Vehicles not equipped with OEM trailer tow
package, may require fuses and relays to complete
output & battery feed circuits (sold separately).
Consult owners manual for locations.
WARNING
Overloading circuit can cause fires. DO NOT exceed
lower of towing manufacturer rating or:
• Max.4 axles: 8 brakes (24 amps)
Read vehicle's owners manual and instruction
sheet for additional information.
12/13/21
a