Quick Start; Installing The Sim Card - Microhard Systems VIP4G Mode D'emploi

2.0 Quick Start

This QUICK START guide will walk you through the setup and process required to
access the WebUI configuration window and to establish a basic wireless connection
to your carrier.
Note that the units arrive from the factory with the Local Network setting configured
as 'Static' (IP Address 192.168.168.1, Subnet Mask 255.255.255.0, and Gateway
192.168.168.1), in DHCP server mode. (This is for the LAN Ethernet Adapter on the
back of the VIP4G unit.

2.1 Installing the SIM Card

 Before the VIP4G can be used on a cellular network a valid SIM Card for your
To reset to factory
defaults, press and
hold the CFG button
for 8 seconds with the
VIP4G powered up.
The LED's will flash
quickly and the IP4G
will reboot with factory
2.2 Getting Started with Cellular
defaults.
 Connect the power connector to the power adapter and apply power to the unit,
Use the MHS-supplied
power adapter or an
equivalent power
source.
© Microhard Systems Inc.
Wireless Carrier must be installed. Insert the SIM Card into the slot as shown
below.
SIM Card Slot
once the blue CPU LED is on solid, proceed to the next step.
9-30VDC
3