Beper BT.700Y Mode D'emploi page 6

Crepe Maker Use instructions
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable mate-
rials, gases or burning flames.
Do not allow children, disabled people or every pe-
ople without experience or technical ability to use
the appliance if they are not properly watched over.
Close supervision is necessary when any appliance
used by or near children.
Description Fig. A
1. Operating light (GREEN)
2. Temperature indicator light (RED)
3. Non-stick cooking plate
4. Switch on/off and temperature selection knob
5. Main unit
6. Wooden T stick
Use instructions
Before first use, remove the packing and stickers from the unit and clean the cooking plate with a wet cloth, than
wipe carefully.
Connect the appliance to the socket, the operating and the temperature indicator light will turn on.
Turn the knob to select the desired temperature, the temperature indicator light will switch off till the cooking plate
will reach the selected temperature.
When cooking crepes, pre-heat the cooking plate, set the temperature then pour a small quantity of batter in the
middle of the cooking plate. Spread the batter quickly in a circular motion using the wooden rack till the desired
diameter crepes is reached.
Let the crepe cooks till the batter will look solid than it can be moved more easily on the cooking plate.
Place a spatula under the crepe and turn the crepe on itself in order to cook it on the other side.
Cook until the crepe is lightly golden.
Remove the crepe from the cooking plate with the spatula. If the crepe is too cooked, set a lower temperature
before making a new one. When cooking completed, turn off the appliance by turning the knob on "OFF" position.
Disconnect the appliance from the socket. Leave the appliance cool down, than clean it before storing.
Cleaning and care
Clean the appliance after each use. Make sure the unit will be disconnected from the socket.
Wait until the unit is completely cool down.
Clean the cooking plate with a wet cloth. If the residue on the cooking plate is hard to remove, use this method:
put some oil on it. Leave it for about 5 minutes, and remove with a wet soft, and wipe carefully.
Roll the cord under the unit base, and stand the appliance on its base. Do not put any objects on the appliance.
Technical data
Power: 1300W
Power supply: 220-240V ~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
6