Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING ! Once in place, the mower must be shut down to prevent accidental starting
(refer to the machine manual) by removing the ignition key or unplugging a spark plug,
for example.
Note: before lifting the mower, remove the
accessories installed on the riding mower
(recovery bins, mulching, ...).
6. Operate the crank clockwise to raise the mower
2 to 3 cm. Make sure your mower is properly
balanced on the jack lift before continuing with the
lift. The 2 wheels of the axle of the lawn mower
must be fully rested on the jack lift. Check that the
mower is not in danger of tripping over.
In case of imbalance, turn the crank counterclockwise to rest the mower on the ground.
Check that the axle that rests on the lawn mower is the heaviest. If not, place the other
axle on the jack lift.
Check that no accessories are loaded on the axle that is not on the lawn mower.
WARNING ! Do not lift the machine if it is not stable. It may tip over causing serious
injury.

IV- USE

Place the lawn mower on a
stable, flat and horizontal
surface.
5. Park lawn mower on the jack lift
by tilting the mower base against
the support at the opposite of the
jack lifting screw.
Note: For mini-tractor type lawn
mowers, place the backs on the
lawn mower. Rear wheel plated on
the lateral reinforcement (5) at the
opposite of the jack lifting screw.
In general, place the axle on which
the engine (heavier axle) is located
on jack lift to prevent the lawn
tractor from tipping over.
8

Publicité

Table des Matières
loading

Table des Matières