Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS - RATIO AREA
I
L
I
L
NOTES:
For replacement LED Assemblies and Drivers please contact Hubbell Lighting for any replacement parts.
Contact your local distributor or agent to confirm parts availability prior to ordering replacement parts.
93157864 Rev. A
701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000
SAVE THESE INSTRUCTIONS
ACCESS TO 1/2-13 HEX HEAD BOLT
LOOSEN TO ADJUST ANGLE
J
TIGHTEN TO 35 FT/LBS
J
K
J
J
M
Deco Knuckle Arm Mount
Fixture Installation:
1.
Take bottom cover (K) off of deco knuckle arm using
T-20 screwdriver to remove #8-32 screw.
2.
Attach the deco knuckle to pole (L) by position sliding
nut block (I) inside the pole at pre-drilled hole locations
and fastening the arm to the pole using the 1/2-13 bolts
(J). Finger tighten first, then tighten fully to 50 ft-lbs.
Aim Adjustment:
•
Determine the desired vertical aim angle before
attempting adjustments.
•
Notice that there are tick marks are at 15° intervals, plus
long tick marks at 0°, 45° and 90°. The knuckle will
actually allow finer adjustments to 4° per step.
•
Remove the center hub cover (H)
•
Notice the large 1/2-13 hex head bolt in the center of the
hub acts as a pivot and should be loosened slightly for
adjustment, but never removed.
CAUTION: secure housing assembly or obtain help
holding and positioning the fixture while adjusting the
aim .
•
Aim the fixture to the desired angle.
•
Once the aim angle has been completed, tighten the
1/2-13 Hex Head pivot bolt to 35 ft-lbs.
•
Replace the Knuckle cover (H).
Deco Arm Mount
Fixture Installation:
1.
Take bottom cover (K) off of deco knuckle arm using
T-20 screwdriver to remove #8-32 screw.
2.
Attach the deco knuckle to pole (L) by position sliding
nut block (I) inside the pole at pre-drilled hole locations
and fastening the arm to the pole using the 1/2-13 bolts
(J). Finger tighten first, then tighten fully to 50 ft-lbs.
www.beaconproducts.com
SHEET 3 OF 4
Publicité
