Agio 965441 Instructions D'assemblage page 7

5. Slide the tank drawer out and place the LP tank in the drawer. Connect the regulator
as shown in Figure 6. Turn the black handle clock-wise to tighten. Turn the handle
counter clock-wise to remove. The hose must point down. Check that the valve is
turned all the way clockwise to the "OFF" position. Open the tank valve. Apply a
solution of soapy water to the tank-regulator connection and to the valve-hose
connection to check for leaks. If soap bubbles continue to form, the connection has a
leak. If a leak is found, close the tank valve and tighten all connections.
NEVER USE A FLAME TO CHECK FOR LEAKS.
Figure 6
6. Tighten threaded knobs (L) found on tank tray (Figure 7) so that the LP tank cannot
move from side to side. Do not remove plastic cap from end of threaded section.
Jul-01-2015
Figure 7
7