Chef'sChoice 673 Mode D'emploi page 4

• A short power supply cord is provided with this appliance to reduce the risk of someone becoming entangled in or tripping
over a longer cord and causing the Kettle to overturn, discharging its hot contents. While EdgeCraft does not recommend
it, extension cords are available and may be used if care is exercised in their use. If an extension cord is used, it should be
a grounded three conductor cord rated at not less than 15 amperes and match the
configuration of the plug. The longer cord should be arranged so that it will not drape over the countertop or
tabletop where it can be pulled on or tipped over by children or the infirm.
• Plug base unit into a three way grounded 110-120 volt, AC outlet.
• The Kettle power switch (2) has 2 positions - "ON" (I) and "OFF" (O). Place Kettle on it's base and push the switch down to
the "ON" position. The light (5) at the bottom of the kettle will illuminate to indicate the power is on.
• The Kettle normally switches off automatically within about 30 seconds after the boiling point is reached.
• The time required for the Kettle to automatically switch off after the boiling point is reached will vary depending on the
amount of water in the Kettle; it will switch off faster after boiling if filled to its "maximum" level than if filled to only a
minimum level.
• If only warm water is desired, you can interrupt the heating procedure at any time by simply lifting the kettle off of its
power base. In order to restart the heat-
ing, place the kettle on its power base
and verify power switch (2) is in the
"ON" (|) position. The operation light will
light up indicating that the power is on.
• The Kettle can be lifted easily from the
base for pouring or serving. The pouring
spout has been specially designed to
easily pour even small amounts of water.
• Replace the Kettle on the base unit when
finished pouring.
• The power switch must be pushed to
the "ON" (|) position again if you wish to
restart the heating of the water. Always
check the water level before turning the
power switch "ON". Make certain there
are at least three cups (0.7 liters) of water
in Kettle before turning switch "ON". Avoid
boiling the kettle dry.
7
8
5
9
4
10
Figure 1.
4
1
2
6
3
1. Lid release button
2. Power Switch
3. Water Level Gauge
4. Base Unit
5. Illuminated Operation Light
6. Handle
7. Spout
8. Stainless Steel Body
9. 360° Power Connector
10. Filter Screen