Table des Matières
Publicité
EN
IMPORTANT
Please read these instructions carefully before you start to assemble this product .
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
Safety Advice
• For safety purposes we strongly recommend the product to be assembled by at least two people.
• Some parts may have sharp edges. Please be careful when handling components. Always wear
gloves, eye protection, and long sleeves when assembling or performing any maintenance on your
product.
• Do not attempt to assemble the product in windy or wet conditions.
• Do not attempt to assemble the product if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
• Dispose of all plastic bags safely – keep them away from children's reach.
• Keep children away from the assembly area.
• When using a stepladder or power tools, make sure that you are following
the manufacturer's safety advice.
• Keep roof and gutters clear of snow, dirt & leaves.
• Heavy snow load on the roof can make it unsafe to stand below or nearby.
• Do not lean against or push the product during construction.
• Hot items such as recently used grills, blowtorches etc. must not be stored inside the product.
• Heavy or sharp articles should not be leaned against the wall panels.
• Make Sure there are no hidden pipes or cables in the ground before inserting the pegs (not supplied)
• Do not touch overhead power cables with the aluminum profiles.
• If color was scratched during assembly it can be fixed.
• Note: This product must be anchored on to a leveled surface and solid foundation to ensure its
stability.
Make sure that screws and anchors are compatible with foundation type. Make sure that there are no
obstructions between the assembly area and the final position.
Cleaning Instructions
• In order to clean the product, use a mild detergent solution and rinse with cold clean water.
• Do not use acetone, abrasive cleaners, or other special detergents to clean the panels.
• Clean the product once assembly is complete.
Before Assembly
• Choose your site carefully before beginning assembly.
• The ground surface must be perfectly flat and leveled.
• Choose a sunny area, away from overhanging trees.
• Do not position your product in an area exposed to excessive winds.
• The product must be positioned and fixed onto a flat leveled surface.
We strongly recommend to secure this product directly onto a solid foundation.
Use the pre-drilled holes in the steel base.
• Complete site preparation before unpacking parts and beginning assembly.
• Sort the parts and check against the content parts list.
• Parts should be laid out close at hand. Keep all small parts (screws etc.) in a bowl so they
do not get lost.
• Please consult your local authorities if any permits are required prior to constructing the
product.
Publicité
Table des Matières
